Aktív tartó fix bekötéssel

Aktív tartó fix bekötéssel

Samsung Galaxy Tab Active Pro T540/T545/T547/T547U

EAN: 7320287131499
Cikkszám: 713149
Csak eredeti tokkal használható
Bruttó ár:  59 094.-HUF
Mennyiség:
1
Összehasonlítás:

Az alábbiakkal kompatibilis

Samsung Galaxy Tab Active Pro T540/T545/T547/T547U

Telepítési útmutató

install-image-1
1. ábra
install-image-2
2. ábra
install-image-3
3. ábra
install-image-4
4. ábra
Mielőtt elkezdené a telepítést, kérjük, olvassa el a használati útmutatót és tekintse át a képeket.

1. Csatlakoztassa az eszközt az USB csatlakozón keresztül. Nyomja a kábelt az aljzatba, majd helyezze a fedelet az előfúrt furatokra és rögzítse a mellékelt csavarokkal.

2. Lazítsa meg a tartó közepén a csavart, így eltávolíthatja a csukló hátsó részét. Helyezze a csukló talp részét a kívánt helyre. Ezután rögzítse a mellékelt csavarokkal. Helyezze a tartót a talp fölé úgy, hogy az illeszkedjen a csuklóval. Húzza meg a csavarokat, amíg a tartó szorosan a helyére nem kerül, de ez később még állítható.

3. Az eszköz behelyezése a tartóba: helyezze az eszköz alját a tartóba, majd nyomja a felső részét előre. Az eszköz kivétele a tartóból: nyomja felfelé a tartó felső részét, ezzel egy időben húzza ki az eszköz felső részét, majd emelje ki az eszközt a tartóból.

4. A tartó a helyére került.

Termékinformáció

Fits for devices with original skin. With tilt swivel and USB Host.
Use an active holder for your Galaxy Tab Active Pro while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Charging via pogo plug. Professional installation recommended.   Easy-switching system: The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.   The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car.   Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.   An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

Hasonló termékek